Contents - Table Of Contents
- Safety Awareness
- About Your Refrigerator
- Door bin slide (N64X, N64XXX, N64XIM, N64XIMXX, N84X, N84XXX, N84XIM, and N84XIMXX models )
- Interior light
- Temperature switch monitor
- Automatic mode operation
- Set the controls to automatic mode operation
- Operating the Refrigerator Controls (N64X, N64XXX, N64XIM, N64XIMXX, N84X, N84XXX, N84XIM, and N84XIMXX models)
- Removing air from the propane gas supply lines
- Set the controls to manual mode operation
- Effects of Freezing Temperatures on Refrigerator Operation
- Refrigerator Care Checklist
- Cleaning
- Metal doors
- Refrigerator Storage
- Refrigerator Maintenance
- Remove the Refrigerator
- Wiring Diagram and Pictorial
- Ice Maker Wiring Pictorial and Diagram (N64X-IM, N64XIMXX, N84X-IM, and N84XIMXX models)
- Ice Maker Wiring Pictorial and Diagram (model N843-IM)
- Wiring Diagram and Pictorial - Low Ambient Heater (optional)
- Fault Codes (N62X, N62XXX, N82X, and N82XXX models)
- sens de la prudence
|
Owner’s Manual 12- On 2-way models only, if neither 120 volts AC nor propane gas is available to the refrigerator:- The fault codes “no” “AC” and then “no” “FL” show in the center display and an audible alarm sounds.- On 3-way models only, if neither 120 volts AC nor propane gas is available to the refrigerator:- The refrigerator control will automatically change to DC electric operation.DC electric operation is less efficient than AC electric and propane gas. Use DC electric operation only tomaintain the refrigerator temperature while in transit and if the other energy sources are not available. Do notuse DC electric to initially decrease the temperature of the refrigerator.If an energy source is available to the refrigerator, but is not operating correctly:- A fault code shows in the center display.- The refrigerator controls try to change to a less efficient energy source.- If a less efficient energy source is not available:- An audible alarm starts.- A fault code shows in the center display.- Refer to the “Fault Codes” section of this manual.Set the controls to manual mode operation:- Push the ON / OFF button to turn the refrigerator on.- Push and hold the MODE button until the letters “ AC” show in the center display and then release.- After ten seconds, the “AC” goes off and only a green power ON light remains.- Push and hold the MODE button until the letters “LP” show in the center display and then release.- After ten seconds, the “LP” goes off and only a green power ON light remains.- Push and hold the MODE button until the letters “ dC” show in the center display and then release.- After ten seconds, the “dC” goes off and only a green power ON light remains.If the energy source is interrupted:- A fault code shows in the center display.- Refer to the “Fault Codes” section of this manual.Effects of High Altitude on Propane Gas OperationWhen you operate the refrigerator on propane gas at altitudes higher than 5500 feet above sea level:- You may experience reduced cooling performance of the refrigerator.- You may experience burner outages.To avoid these possible problems, Norcold recommends that you operate the refrigerator on AC when at altitudes higher than 5500 feetabove sea level.NOTICE
PreviousNext |