Norcold NX64 Series Owner's Manual

Also see for NX64: Service manual Installation manual

Contents

Norcold NX64 Series Owner's Manual Manual pdf 12 page image

Owner’s Manual 12- Be aware of any cooling changes that are not because of weather, loading, or gas control changes. If changes occur, contact yourdealer or service center.- Make sure the gas supply is propane gas only and not butane or a butane mixture.- When in propane gas operation, examine the appearance of the flame. See “Gas Flame Appearance”.- Make sure the air flow in the lower intake vent, through the refrigerator coils and condenser, and out the upper exhaust vent is notblocked or decreased.- Make sure the area behind the refrigerator is clear. Do not use the area behind the refrigerator for storage of anything, especiallygasoline and other flammable vapors and liquids.DefrostingThe cooling fins of the refrigerator operate at below freezing temperature and will naturally form frost from humidity, which is alwayspresent in the air. The humidity inside the refrigerator increases:- with higher outside temperature and humidity.- with the storage of non-sealed fresh foods or warm foods.- with the amount of time that the door(s) are open.- with any air leakage into the refrigerator.Although the refrigerator is not frost -free, it is made to limit frost on the cooling fins. At regular intervals, the temperature control systemautomatically melts most of the frost from the cooling fins. The water from the cooling fins drains into a collection cup that is attached tothe back of the refrigerator. The heat of the cooling system evaporates the water from the collection cup.It is normal for frost to collect inside the freezer. Excess frost decreases the cooling performance of the refrigerator. Defrost therefrigerator and freezer as necessary:- Remove all food from the refrigerator.- Turn the refrigerator OFF.Defrosting the refrigerator makes excess water inside the refrigerator.- Remove the drain hose from the drip cup at the rear of the refrigerator.- Put the drain hose into a half-gallon or larger container to capture water.- Put dry towels (etc.) inside the refrigerator and freezer to absorb melted frost.High temperatures can cause the inside surfaces of the refrigerator to warp or melt. Do not use pans ofHOT water, a hair dryer, or any other high temperature devices to defrost the refrigerator. Do not use anyhard or sharp objects to remove frost. Damage to the interior of the refrigerator can occur.- To increase the speed of defrosting, put pans of WARM water in the refrigerator and freezer.- Remove the wet towels (etc.) and dry the interior.- Remove the drain hose from the large container and put the drain hose back into the drip cup.- Remove the large container from the enclosure.- Start up the refrigerator.- Allow the refrigerator to cool down.- Return all food to the refrigerator.CAUTION!NOTICE