Nordic ID EXA51 User Manual

Also see for EXA51: Quick guide User guide Quick guide

Nordic ID EXA51 User Manual Manual pdf 18 page image

Nordic ID Group | Joensuunkatu 7 | FI-24100 Salo |FinlandOffice +358 2 727 7700 | Fax + 358 2 727 7720 | info@nordicid.com 18 / 272017-09-22Nordic ID EXA51 and Nordic ID EXA51e User GuideVersion 1.7NOTE! XXXXX is a serial number of the Nordic ID EXA511.10.3.1. CONFIGURING HID MODE VIA APPLICATION1. Install Nordic ID RFID Demo application (see section 2.1)2. Connect your device3. Turn on HID mode, RFID and/or barcode mode in reader settings4. Close application and make sure Bluetooth connection is closed5. Reboot your EXA51 device by pressing the power button for 2...3 seconds.1.11. OPERATING WITH HID MODESHID BARCODE ENABLEDReading Barcode:• Pressing trigger down  barcode aimer starts Releasing trigger scanning start• When tag found, result is sent to HID immediately• Pressing trigger down during scan  scanning abortedHID RFID ENABLEDReading RFID tags:• Pressing trigger down  RFID reading starts• Reader read tags in memory as long trigger is kept down. Short beep when new tags found• Releasing trigger  Reading stops and tags in memory will be transmitted to HID. Short beep whensingle tag sent. If no tags found, double low note beeps.BOTH: HID BARCODE & HID RFID ENABLED.Activate Barcode reader:• Trigger click (short press (<350ms) and released immediately)  Barcode scanning start immediatelywithout aiming.• Trigger press and keeping down at least 350ms  Barcode aimer starts Trigger released scanning starts.Activate RFID reader:• Pressing trigger “double click” and keeping down  RFID reading start. Searching tags. Beep whentags found.• Releasing trigger  Reading stop and tags in memory will be transmitted to HID. Short beep whensingle tag sent. If no tags found, double low note beeps.