NordicTrack 30510.1 User Manual

Also see for 130 Elliptical: User manual Manuel de l'utilisateur User manual

Contents

913. Apply a thin film of grease to one of the Pedal Leg Axles(32) and to the faces of the two Pedal Leg Bushings(33) in the Left Pedal Leg (14).Next, slide an M8 Washer (88) and a Pedal Leg Cover(31) onto an M8 x 23mm Shoulder Screw (115), andturn the Shoulder Screw a few turns into the Pedal LegAxle (32).While another person holds the front end of the LeftPedal Leg (14) inside of the bracket on the Left UpperBody Arm (11), insert the Pedal Leg Axle (32) into bothparts. Next, slide an M8 Washer (88) and a Pedal LegCover (31) onto another M8 x 23mm Shoulder Screw(115), and turn the Shoulder Screw a few turns into thePedal Leg Axle. Tighten both Shoulder Screws.Repeat this step on the other side of the elliptical exer-ciser.14. Lift the latch on the underside of the Left Pedal Leg(14), and set the Left Pedal Leg on the left CrankBushing Sleeve (43). Release the lever, and make surethat the Left Pedal Leg is securely connected to theCrank Bushing Sleeve.Connect the Right Pedal Leg (not shown) in the sameway.See step 5. Tighten the M8 x 69mm Button Bolt (80)and the two M8 x 23mm Button Screws (84).12. Identify the Left Pedal (13) and the Left Pedal Leg(14), which are marked with stickers.Attach the Left Pedal (13) to the Left Pedal Leg (14)with an M4 x 45mm Screw (108), three M4 x 14mmScrews (104), and four Star Washers (112).Attach the Right Pedal (not shown) to the Right PedalLeg (not shown) in the same way.15. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may beleft over after assembly is completed. To protect the floor or carpet from damage, place a mat under theelliptical exerciser.Grease1311532883112113114Latch14431314104104112 112112 11214108128833Grease115