NordicTrack COMMERCIAL NTEL16907.0 User Manual

Also see for 1300 Elliptical: Manual User manual User manual Manual Del Usuario

Contents

NordicTrack COMMERCIAL NTEL16907.0 User Manual Manual pdf 20 page image

20Inspect and tighten all parts of the elliptical exerciserregularly. Replace any worn parts immediately.To clean the elliptical exerciser, use a damp cloth anda small amount of mild soap. IMPORTANT: To avoiddamage to the console, keep liquids away fromthe console and keep the console out of directsunlight.CONSOLE TROUBLESHOOTINGIf the console does not turn on, make sure that thepower cord is fully plugged in. If the console does notdisplay your heart rate when you hold the handgrippulse sensor, or if the displayed heart rate appears tobe too high or too low, see step 5 on page 14.HOW TO CALIBRATE THE RAMPIf the ramp is not functioning properly, the ramp mayneed to be calibrated. To calibrate the ramp, holddown the Start button and the Resistance increasebutton for about 5 seconds until the display on theconsole changes. Next, press the Start button once,and then press the Ramp increase button. The rampwill move upward and downward as it calibrates.Then, two dashes and the word RAMP will appear inthe display. The ramp is now calibrated.HOW TO ADJUST THE BELTIf the pedals slip while you are pedaling, even whilethe resistance is adjusted to the highest setting, thebelt may need to be adjusted.To adjust the belt,first carefully pryoff the right DiscCover (41) usinga flat screwdriver.Next, remove thefour screws (notshown) from thecenter of the rightPedal Disc (40).Gently rotate theDisc away fromthe elliptical exerciser.Loosen, but donot remove, thethree indicatedscrews (A). Insertthe shaft of ascrewdriverdownwardbetween theIdler (B) and theIdler Pulley (C).Pull the top of thescrewdrivertoward the frontof the elliptical exerciser until the Belt (57) is tight.Then, tighten the three screws.Reattach the right disc with the four screws and thenreattach the right disc cover.MAINTENANCE AND TROUBLESHOOTING4140BCA57