5M8 NylonLocknut (72)–4M4 x 19mmScrew (57)–2M10 SplitWasher (85)–20M10 Washer(67)–14M8 SmallWasher (18)–4M8 Washer(69)–4M8 x 55mm BoltSet (92)–2M10 x 116mm Carriage Bolt (38)–2M8 x 38mm ButtonBolt (58)–4Wave Washer(88)–4M10 x 123mm Button Screw (87)–2M10 NylonLocknut (70)–2M4 x 16mmScrew (47)–6Thrust Washer(66)–4M10 x 13mm ButtonScrew (54)–14M10 x 65mm BoltSet (94)–2M8 x 19mm ButtonScrew (56)–4M10 x 25mm PatchScrew (48)–4ASSEMBLYAssembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove thepacking materials. Do not dispose of the packing materials until assembly is completed. In addition to the in-cluded tools, assembly requires a Phillips screwdriver , an adjustable wrench ,and a rubber mallet .As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. Thenumber following the parentheses is the quantity needed for assembly. Note: Some small parts may have beenpreassembled. If a part is not in the hardware kit, check to see if it has been preassembled.