NordicTrack EX 1000 NTEL4255.1 User Manual

Also see for EX 1000 Commercial PRO: User manual

Contents

99. Apply a film of grease to the barrel of an M8 x 55mmBolt Set (92) and to a 7mm Spacer (55). Slide anM8 Washer (69) and the Spacer onto the barrel.While another person holds the front end of theLeft Pedal Leg (14) inside of the bracket on the leftHandlebar Leg (17), insert the barrel of the BoltSet (92) through both parts. Next, slide a 7mmSpacer (55) and an M8 Washer (69) onto the endof the barrel of the Bolt Set. Then, turn the screwof the Bolt Set a few turns into the barrel. Do notovertighten the Bolt Set; the left Handlebar Legmust be able to pivot freely.Attach the right Handlebar Leg (not shown) to theRight Pedal Leg (not shown) in the same way.See step 7. Tighten the four M8 x 38mm ButtonScrews (58).10. While another person holds the Display Console(74) and the Control Console (75) near the Upright(2), connect the Pulse Jumper Wire (76) to the con-sole pulse wire, and the Upper Wire Harness (77)to the console wire harness. Insert the excesswires into the Upright.Set the Consoles (74, 75) on the Upright (2). Attachthe Consoles with six M4 x 16mm Screws (47).Make sure that no wires are pinched. Do nottighten the Screws yet.1491029217 925555 69694747 7776757411. Attach the Water Bottle Holder (26) to the Upright(2) with two M4 x 19mm Screws (57).See step 10. Tighten the six M4 x 16mm Screws(47).112Grease265712. Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the el-liptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.