NordicTrack NTEL05011.4 User Manual

Also see for E 5.7: User manual Manual User manual User manual User manual

Contents

NordicTrack NTEL05011.4 User Manual Manual pdf 24 page image

24Inspect and tighten all parts of the elliptical regularly.Replace any worn parts immediately.To clean the elliptical, use a damp cloth and a smallamount of mild soap. IMPORTANT: To avoid damageto the console, keep liquids away from the consoleand keep the console out of direct sunlight.CONSOLE TROUBLESHOOTINGIf the console does not display your heart rate whenyou hold the handgrip heart rate monitor, or if the dis-played heart rate appears to be too high or too low, seestep 5 on page 19.HOW TO LEVEL THE ELLIPTICALIf the elliptical rocks slightly on your floor during use,see HOW TO LEVEL THE ELLIPTICAL on page 15.HOW TO GREASE THE ROLLERSSee the EXPLODED DRAWING near the end of thismanual. If the Rollers (51) squeak when moving onthe Tracks (16), apply a small amount of white marinegrease equally to each Roller. Spread the greaseevenly around the Rollers. Pedal the elliptical until athin lm of grease is distributed along the Tracks; then,wipe off any excess grease.HOW TO ADJUST THE REED SWITCHIf the console does not display correct feedback, thereed switch should be adjusted.See EXPLODED DRAWING C on page 31. Using aflat screwdriver, remove the left Disc (71).Note: For clarity, the left shield is shown removed in thedrawing below.Next, locate the Reed Switch (38). Turn the Pulley (19)until a Magnet (43) is aligned with the Reed Switch.Loosen, but do not remove, the indicated M4 x 16mmScrew (101). Slide the Reed Switch (38) slightly closerto or away from the Magnet (43), and then retightenthe Screw. Then, rock the Pulley (19) forward andbackward just enough that the Magnet passes theReed Switch repeatedly.Repeat these actions until the console displays correctfeedback. When the reed switch is correctly adjusted,reattach the left disc.MAINTENANCE AND TROUBLESHOOTING381910143