24Inspect and tighten all parts of the elliptical regularly.Replace any worn parts immediately.To clean the elliptical, use a damp cloth and a smallamount of mild soap. IMPORTANT: To avoid damageto the console, keep liquids away from the consoleand keep the console out of direct sunlight.CONSOLE TROUBLESHOOTINGIf the console does not display your heart rate whenyou hold the handgrip heart rate monitor, or if the dis-played heart rate appears to be too high or too low, seestep 5 on page 19.HOW TO ADJUST THE REED SWITCHIf the console does not display correct feedback, thereed switch should be adjusted.To adjust the reedswitch, you mustfirst remove the TopShield (20). Usinga flat screwdriver,release the tabs onthe front and rear ofthe Top Shield andthen remove the TopShield.Next, locate the Reed Switch (69). Loosen, but do notremove, the M4 x 16mm Screw (93).Next, rotate the Large Pulley (74) until a Magnet (75)is aligned with the Reed Switch (69). Slide the ReedSwitch slightly toward or away from the Magnet. Then,retighten the M4 x 16mm Screw (93).Rotate the Large Pulley (74) for a moment. Repeatthese actions until the console displays correctfeedback.When the reed switch is correctly adjusted, reattachthe top shield.MAINTENANCE AND TROUBLESHOOTING2093757469