Instruction SheetPart 1047722A 2004 Nordson CorporationP/N 1047722AEPC-15 Container Firmware Chip InstallationWARNING: Allow only qualified personnelto perform the following tasks. Follow thesafety instructions in this document and allother related documentation.Kit ContentsThe EPC-15 Container firmware chip kit,part 1047694, consists of these items: Firmware chip Chip removal tool Grounding wrist strap Firmware identification labelThe firmware chip contains the software necessaryto use the EPC-15 Eclipse Series pattern controllerwith a container coating system.InstallationWARNING: Disconnect and lock outpower before performing the followingtasks. Failure to observe this warningcould result in equipment damage,personal injury, or death.1. See Figure 1. Remove the three screws (1)securing the lower housing (2) to the controller.2. Pull the lower housing down to disengage itstabs from the controller and remove it.3. Remove the two screws (3) securing the upperhousing (4) to the controller. Swing the upperhousing up.1200455A12345Figure 1 Removing the Upper and Lower Housings1. Screws (3)2. Lower housing3. Screws (2)4. Upper housing5. Firmware identificationlabelNote: The firmware identification label is included withthe service kit.

Nordson EPC-15 Instruction Sheet