Tribomatic 500 Manual Powder Spray Gun 9Part 237467D02 2007 Nordson CorporationPattern ControlMove the pattern control sleeve back for a wide pattern, forward for anarrow pattern.MicroAmpere DisplayThe control unit display should show 1.4 to 4 microamperes duringoperation. Gun current output varies depending on powder velocity, type ofpowder, and compressed air moisture content. The higher the output, thebetter the powder is charging.MaintenanceWARNING: Allow only qualified personnel to perform the following tasks.Follow the safety instructions in this document and all other relateddocumentation.Perform the following steps daily:1. Remove the powder feed hose from the pump and the air tubing fromthe diffuser. Make sure the booth exhaust fan is on. Point the gun intothe booth and insert a compressed-air blow gun into the end of the feedhose. Blow out the feed hose, diffuser, and gun.CAUTION: When cleaning, always disconnect the air tubing from thediffuser and pump. Powder could travel through the air tubing andcontaminate the solenoid valves, regulators, and gauges in the control unit.Always blow powder into the booth.2. Disconnect the powder feed hose from the diffuser. Remove the diffuserfrom the gun. Blow out the diffuser with low-pressure compressed air.3. Remove the inner and outer charge sleeves from the gun. Clean thesleeves and nozzle with low-pressure compressed air and a clean, softcloth. Refer to Repair for disassembly instructions.CAUTION: Never use a knife or other sharp object that will scratch plasticto clean the gun or pump parts. Powder particles will build up on scratches,fuse together on impact, and clog the gun or pump.4. Disassemble the powder pump and clean the parts with low-pressurecompressed air and a clean, soft cloth. Refer to the pump manual fordisassembly instructions.5. Check all equipment ground connections. Make sure all equipment inthe spray area is connected to a true earth ground.

spray gun

qualified personnel

personal safety

action in the event of a malfunction

Description

specifications

Installation

Operation

Pattern Control

troubleshooting

Nordson Corporation

Repair

Assembly

Outer Charge Sleeve Support and Pattern Adjust Sleeve Replacement

Handle, Trigger, and Cable Replacement

Parts

Gun Parts

Inner Charge Sleeve Kit

Diffuser Kit

Nordson Tribomatic 500 Product Manual

Tribomatic 500