Safety 1-3Part 7119745CE 2007 Nordson Corporation MiniCure 08-07Personal SafetyTo prevent injury follow these instructions.S On a daily basis the Earth Leakage Circuit Breaker and the combinedIsolator (at the connection box) should be tested.S This is carried out by pressing the ’Test’ button while thesystem is switched on -- the Isolator should switch off instantly.WARNING: If the isolator or any indicator remains on, then it could indicatethat a SERIOUS fault is present on your system. Inform your electrician orcontact Nordson UV for advice immediately.NOTE: To protect the Earth Leakage Sensor, this test function will onlywork while the lamps are switched off.WARNING: NEVER LOOK AT A LIGHTED LAMPS ULTRA--VIOLET RADIATION IS HARMFUL TO EYES AND CANBE HARMFUL TO SKIN. ALWAYS WEAR SUITABLEPROTECTION WHEN USING THIS SYSTEM.S THIS SYSTEM IS DESIGNED TO BE USED FOR HAND FEDOPERATION, SPECIAL UV SAFETY GLASSES & GLOVES MUSTBE WORN.Suitable glasses (Part No. 7350033) and gloves (Part No. 7350657) aresupplied with the unit, additional pairs are available from Nordson UV.S Do not operate or service equipment unless you are qualified.S Do not operate equipment unless safety guards, doors, or covers areintact and automatic interlocks are operating properly. Do not bypass ordisarm any safety devices.S Keep clear of moving equipment. Before adjusting or servicing anymoving equipment, shut off the power supply and wait until theequipment comes to a complete stop. Lock out power and secure theequipment to prevent unexpected movement. Wait 2 mins for the lampto cool down.S If you receive even a slight electrical shock, shut down all electricalequipment immediately. Do not restart the equipment until the problemhas been identified and corrected.S Obtain and read Material Safety Data Sheets (MSDS) for all materialsused. Follow the manufacturer’s instructions for safe handling and useof materials, and use recommended personal protection devices.S To prevent injury, be aware of less-obvious dangers in the workplacethat often cannot be completely eliminated, such as hot surfaces, sharpedges, energized electrical circuits, and moving parts that cannot beenclosed or otherwise guarded for practical reasons.