Noritz N-0631S Installation Manual

Also see for N-0531S: Instruction manual Owner's guide Instructional manual Field manual

Contents

Noritz N-0631S Installation Manual Manual pdf 30 page image

30Installing the Remote Controller Outdoor Junction Box1. Insert the remote controller wires through thewall pipe and secure the wall pipe to theremote controller. Locate the remote controllerwall packing, slide it over the pipe and wires,and apply it to the rear side of the remote.2. Drill a 32mm ( 1"-1/4") hole in the wallwhere the remote controller will be installed.* Do not install the remote controller in alocation that is exposed to moisture, directsunlight, or chemical agents. These candamage the remote controller.Rear side of remote controllerWall PackingSecure the wall pipefirmly into the remotecontroller.Take off thepaper.3. Insert the wall pipe containing the remotecontroller wires through the hole.4. Slide the junction box packing and the junctionbox over the remote controller wires and wallpipe protruding from the outside wall.Wall packing Wall pipeTake out the pipe about18.75mm (3/4") from the wall.Junction BoxBox NutJunction Box PackingTake off the paper.5. Slide the box nut over the remote controllerwires and screw it onto the wall pipe.Wall PipeBox NutRemoteControllerWires6. Connect the remote controller wires to theseparate remote controller cord inside the box.Wind the excess remote controller wire on theprovided hooks as illustrated below.(Wind theexcess wirehere.)Remote ControllerWiresJunction BoxRemote ControllerCordTie the redundant length of the remotecontroller cord outside the junction box.7. Close the junction box.RemoteControllerWires