Noritz NCC199-DV Installation Manual

Also see for NCC199-DV: Instructional manual Owner's guide Installation manual Service manual Owner's guide

Contents

Noritz NCC199-DV Installation Manual Manual pdf 24 page image

24Do not connect electrical power to the unit until all electrical wiring has been completed.Consult a qualified electricianfor the electrical work.13. Electrical WiringThis appliance must be electrically grounded in accordance with local codes, or in the absence of local codes,with the National Electrical Code, ANSI/NFPA 70. In Canada, the latest CSA C22.1 Electrical Code.Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improperand dangerous operation.Verify proper operation after servicing.Field wiring to be performed at time of appliance installation.• The electrical supply required by the water heater is120VAC at 60 Hz.The power consumption may be up to 327W or higher ifusing optional accessories.Use an appropriate circuit.• Do not disconnect the power supply when not in use. Whenthe power is off, the freeze prevention in the water heaterwill not activate, resulting in possible freezing damage.• Do not let the power cord contact thegas piping.Tie the redundant power cord out-side the water heater. Putting theredundant length of cord inside thewater heater may cause electricalinterference and faulty operation.Disconnect PowerElectrical Shock HazardDo not turn power on until electrical wiring is finished. Disconnect power before servicing.Failure to do so may result in death or serious injury from electrical shock.WARNINGElectrostatic discharge can affect electronic components. Take precautions to prevent electrostatic discharges frompersonnel or hand tools during the water heater installation and servicing to protect product’s electronic control.CAUTIONGround• To prevent electrical shock, provide a groundwith resistance less than 100 . An electricianshould do this work.• A grounding screw is provided on the back inthe junction box.Do not connect the ground to the city wateror gas piping. Do not tie the ground to a tele-phone line.Breaker Installation• Mount a device which shuts off the electricalpath automatically (leakage breaker) whenelectrical leakage is detected.1. Remove the screw (one) of the junction box andopen the cover of the junction box.2. Connect the grounding wire to the ground screw inthe cover.3. Crimp the outdoor power cable to the power cable ofthe unit.Junction Box Power CordGround