Noritz NR98-SV Installation Manual

Also see for proTough NR98OD: Installation manual Owner's guide Replacement Service manual Owner's guide

Contents

Noritz NR98-SV Installation Manual Manual pdf 24 page image

24Remote controller cord• For extensions, a 7.8m (26') cord can be purchased (Part # RC-CORD26) or use 18AWG wire.• Install according to the National Electrical Code and all applicable local codes.Connecting Remote Controller Cord to Unit• Keep the remote controller cord away from the freeze prevention heaters in the unit.• Tie the redundant cord outside the water heater. Do not put the extra length inside the equipment.• The remote controller cord can be extended up to 90m (300') with 18AWG wire.• Use a Y type terminal with a resin sleeve. (Without the sleeve, the copper wire may corrode andcause problems).• Be sure to hand tighten when screwing to the terminal block. Power tools may cause damage to theterminal block.1. Check to make sure that the remote controller cordhas plenty of slack in order to reach the externalconnection terminal block.2. Disconnect electrical power to the water heater.3. Remove the single screw securing the terminalblock cover and then remove the cover.4. Pass the remote controller cord through the wiringthroughway and connect the Y terminals at the endof the remote controller cord to the terminal block.5. Replace the terminal block cover and install thescrew previously removed in step 3.6. Reconnect electrical power to the water heater.External connectionterminal blockWiring throughwayRemote controller cord