Nortel 1000M Installation And Commissioning Manual

Also see for Meridian Meridian 1: Installation guide Implementation guide Scripting Guide Configuration manual Description

Contents

Installing a Signaling Server Page 429 of 456Communication Server 1000M and Meridian 1 Large System Installation and Commissioning4 Enter the location (loop and shelf) of the IPMG board.Note: If the IPMG has not been configured yet, the loop and shelfinformation can be left at the current value. The IPMG board location canbe updated using OAM shell commands after the Signaling Server isconfigured.5 The Leader/Follower configuration screen appears (Figure 175).Figure 175Leader/Follower Signaling Server configuration6 Configure the Signaling Server as a Leader or Follower. If there is alreadya Leader Signaling Server in the IP Telephony node, enter b at the promptto configure this Signaling Server as Follower. The Follower SignalingServer configuration screen appears (Figure 176). Go to step 15 onpage 421.Please select the role of this Signaling Server.If this Signaling Server will be a Leader then its data networkingand IP Telephony parameters must be entered now. (This will pre-configure the IP Telephony node files.)If this Signaling Server will be a Follower then its data networkingand IP Telephony parameters must be configured through ElementManager later.Please enter: -> - Set this Signaling Server as a Leader. - Set this Signaling Server as a Follower. - Quit.Enter Choice>=====================================================================CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)Note: This step will over-write all existing configuration parameterson this Signaling Server.