Page 68 of 302 Nortel Networks IP Phone 2002553-3001-368 Standard 4.00 February 2005a. If local power is used, plug the AC power transformer into the nearestpower outlet.b. Ensure the correct AC power transformer is used. The voltage ratingof the transformer must match the wall outlet voltage. Refer to Table8 on page 56. Connect the power jack as shown in Figure 6 onpage 61. Be sure to thread the cord around the retaining hook toprovide strain relief for a secure power connection.6 When the Nortel Networks logo appears on the display, immediatelypress the four feature keys at the bottom of the display in sequence fromleft to right.7 At the prompt DHCP Yes/No?, select Yes.8 Select Partial or Full DHCP.a. If you select Full DHCP, then the following parameters are retrievedfrom the DHCP server:— a valid IP Phone 2002 IP address— a subnet mask— the default Media Gateway for the IP Phone 2002 on the LANsegment to which it is connected— the S1 node IP address of the IP line node— the S1 action— the S1 retry count (This is the number of times the IP Phoneattempts to connect to the server.)— the S2 node IP address of the IP line node— the S2 action— the S2 retry count— the External Application Server (XAS) IP addressb. If you select Partial DHCP, then you must enter the followingparameters:Screen prompt DescriptionS1 IP the node IP address of the IP line nodeS1 Port this is a fixed value: 4100S1 action this is a fixed value: 1
