22. Slide the new fan tray into the chassis andtighten the retaining screws.3. When the chassis power is on, verify that thegreen status LED is lit.9591FA 9592FA

about this guide

Nortel Accelar 8006 Installation Manual

New in this release

Introduction

Regulatory information

Chassis installation fundamentals

chassis

Power supplies

Fan trays

Site requirements

co chassis

Hardware requirements

Successful installation veriﬁcation

and 8003 chassis installation

Mounting the chassis in an equipment rack

Installing the cable management brackets

co chassis installation

Mounting the chassis in a Hendry rack

Installing 8004DC power supplies with the BIP

Nortel Ethernet Routing Switch

Switch operations

Powering on AC power supplies

Resetting the switch

Removing removable ﬂash memory cards

Protecting memory card ﬁles

Troubleshooting

Apparent module failure

Module failure workaround 1

Cable connection problems

BASE-T and 1000BASE-T cables

Common procedures

Part numbers

Technical speciﬁcations

Rack-mount

Model 8004AC power supply

Model 8004DC power supply

Model 8005DC power supply

Component input power

AC power supply example

DC power supply example

Environmental speciﬁcations

International regulatory requirements

Index

Accelar 8006

Passport 8006


Contents about this guide	22. Slide the new fan tray into the chassis andtighten the retaining screws.3. When the chassis power is on, verify that thegreen status LED is lit.9591FA 9592FA Previous / 4