Nortel BCM 200 Technical Configuration Manual

Also see for BCM200: Keycode Installation Guide Integration guide Overview Installation and maintenance guide Configuration guide

Contents

Nortel BCM 200 Technical Configuration Manual Manual pdf 11 page image

BCM Technical Configuration Guide V1.1 May, 2006_______________________________________________________________________________________________________________________NORTEL External Distribution 10Figure 6: ISDN DNs - DN 2484The Calling Line ID (CLID) or Outgoing Line Identification (OLI) is the key to ensuring that the far end system willcall back the originating system to complete call setup. In this case, our tests were performed on Nortel’scorporate network, which operates on a five digit dial plan. For these purposes, the OLI was set to the BCM’sprime DN (34190), and was padded with zeros to fill out a full 10 digit as if it was a complete public number.Thus, in a non-PBX implementation, this field would be set to a complete 10 digit number. For example, if thevideoconferencing DN was (905)555-5200, the “Public OLI number” field should be set to 9055555200.Repeat these steps, for both ISDN DNs to be associated with the video unit, using the appropriate 10 digit DNsfor each line.Figure 7: ISDN DNs - Line Access (OLI)To ensure that incoming video calls to DN 34190 are routed to the correct BCM DN, a target line needs to beconfigured. In this example, TL 241 is added to the DN 2485. This is completed via the “add” button seen in thefigure below.