Chapter 3 Configuring the BCM50 system 31BCM50 First Time Installation and Configuration GuideUsing Telset Administration to configure the systemYou can use the following Telset Administration procedures to configure some of the basicparameters of your system. Use Element Manager to configure any other parameters.Use the following procedures to configure the initial parameters for the BCM50 using TelsetAdministration:• “To work with keycodes, IP addresses, modem properties, and user accounts”• “To select the region”• “To select the telephony startup template and start DN”• “To initialize voice mail” on page 32To work with keycodes, IP addresses, modem properties, anduser accountsBCM50 provides a Telset-based interface to administer keycodes, IP addresses, modemproperties, and user accounts. To access this interface:1 Select feature 9*8 from a two-line display telephone.2 Enter the following user ID and password:Username: SETNNAPassword: CONFIGThe numerical values of the user ID and password are 738662 and 266344, respectively.For details about configuring these parameters, refer to the BCM50 Installation and MaintenanceGuide (N027152).To select the regionYou set the region using Feature **PROFILE from a two-line display telephone.Refer to the BCM50 Telset Administration Guide (N0027176) for information on using TelsetAdministration to set this parameter.To select the telephony startup template and start DNYou set the template and start DN using Feature **STARTUP from a two-line display telephone.Note: BCM50 reintroduces Telset Administration. A technician can administermany aspects of the system using Telset Administration, although ElementManager is required to administer the data startup parameters (see Table 7 on page27 and Table 8 on page 28 for details).Note: You only have 15 minutes after system bootup to set these parameters.