Nortel BSG12aw Installation Manual

Also see for BSG12aw: Quick start guide

Nortel BSG12aw Installation Manual Manual pdf 65 page image

Basic procedures 65Installation1 Remove all of the cables from the unit.To disconnect cables, see “Disconnecting the cables” on page 65.2 If a unit is mounted to the top of another unit, slide that unit forward until itdisengages from the clips on the lower unit. Lift the unit off of the top of the lowerunit.3 Lift the unit off of the table.4 Set the unit on a flat, clean, static-free surface.EndDisconnecting the cablesUse this procedure to disconnect the cables from a BSG8ew/12ew/aw/tw.Procedure stepsStep Action1 Remove the FXO RJ-11 connection.2 Remove the FE connections from the LAN ports.3 Remove the WAN connection from the WAN ports.4 While disconnecting a BSG8ew, rotate the power supply retention clip to free thepower supply cord.5 Remove the power supply cord from the unit.EndConnecting the cablesFor connecting the cables, see “Cable connection” on page 45.Caution: Risk of leakage currentsYou must disconnect the telephony and data networking cables from the systembefore disconnecting the power cord from a grounded outlet.

/ 66

Related manuals for Nortel BSG12aw