Configuring system identification 87Table 13Job aid: Setup utility prompt descriptions (cont’d.)Prompt Description and actionIP address of the default VLAN[0.0.0.0/0.0.0.0]:Description: Specifies the IP address of thedefault Virtual Local Area Network (VLAN).Action: Type the IP address of the defaultVLAN.Do you want to save thechanges[Saving the parametersupdates the files /flash/boot.cfgand /flash/dvmrp_pol.cfg](y/n)?Description: Saves your changes to the bootand run-time configuration files.Action: Enter y to save the boot and run-timeconfiguration files. Enter n if you do not wantto save your changes.Configuring system identificationConfigure system identification to specify the system name, contactperson, and location of the switch.Prerequisites• You must log on to the Global Configuration mode in the NNCLI.Procedure stepsStep Action1 Change the system name by using the following command:sys name 2 Configure the system contact by using the following command:snmp-server contact 3 Configure the system location by using the following command:snmp-server location --End--Variable definitionsUse the data in the following table to use system-level commands.Variable Valueagent-conformance Enables agent conformance mode.Nortel Ethernet Routing Switch 8600CommissioningNN46205-319 01.01 Standard30 May 2008Copyright © 2008 Nortel Networks.
