Using the toolbar 45Menu DescriptionEdit The Edit menu lets you view parameters for the chassis orfor selected objects, such as ports. This menu also lets youset security parameters, run diagnostic tests, and select allobjects in the device.Graph The Graph menu lets you view chassis or port statistics.IP VLAN The IP VLAN menu lets you set up VLANS for the switch.IP Routing The IP Routing menu lets you set up IP routing and Quality ofService (QoS) functions for the switch. It also allows you toperform traffic control.Layer 2 The Layer 2 menu lets you set up FDB, GVRP, InternetGroup Membership Protocol (IGMP), Multicast FDB, portmirroring, Spanning Tree, and current and static VLANs forLayer 2 mode. The device must be reset for Layer 2 for thismenu to function.QinQ The Q-in-Q menu lets you set up a VLAN for Q-in-Q mode(applies to the ESU 1850 only).PacketClassificationThe Packet Classification menu lets you perform filtering,metering, packet classification, and packet policing.Rmon The RMON menu lets you set up and view remote monitoring(RMON) alarms.Rapid Ping The Rapid Ping menu lets you test traffic data issues such asconnectivity, latency, and packet loss.Actions The Actions menu provides quick access to selected actionswithout going through other menus and submenus. Use thismenu to open the Web management interface and saveruntime configurations.Help The Help menu lets you view online Help topics for DeviceManager. This menu also provides a legend for the portcolors in the device view.Using the toolbarThe toolbar buttons provide quick access to commonly used commands andsome additional actions for the Metro Ethernet Routing Switch 8600, MetroESU 1800, and Metro ESU 1850.describes the toolbar buttons for the Metro Ethernet Routing Switch 8600,and Metro ESU 1800 and 1850.Nortel Metro Ethernet Routing Switch 8600Fundamentals — Using Device ManagerNN46225-300 02.02 Standard4.2 1 October 2007Copyright © 2005-2007, Nortel Networks.