Installing an XFP 33Model number Product number Description10GBASE-ER/EW AA1403003-E5 1550 nm SMF. The range is up to 40 km.10GBASE-ZR/ZW AA1403006-E5 1550 nm SMF. The range is up to 80 km.Installing an XFPInstall an XFP to provide a 10 Gigabit Ethernet interface between the switchand other network devices.Installing an XFP takes about 3 minutes.Prerequisites• Verify that the XFP is the correct model for your network configuration.Procedure stepsCAUTIONNortel recommends that you install only one 10GBASE-ZR/ZWper module due to cooling limitations on the 8683XLR and8683XZR modules. Nortel further recommends the installation ofthe XFP only in port 1. You can install a 10GBASE-SR, -LR/LW, or-ER/EW in one or both of the remaining ports.CAUTIONXFPs are keyed to prevent incorrect insertion. If the XFP resistspressure, do not force it; turn it over, and reinsert it.Step Action1 Remove the XFP from its protective packaging.2 Grasp the XFP between your thumb and forefinger.3 Insert the XFP into the XFP slot on the module.Apply a light pressure to the XFP until the device clicks and locksinto position in the module.Nortel Metro Ethernet Routing Switch 8600Installation — SFP, XFP, and GBIC Hardware ComponentsNN46220-301 02.02 Standard4.2 13 November 2007Copyright © 2007, Nortel Networks.
