Northwest 80-2000A-36 Installation And Operating Instructions Manual
        | |
3. Always unplug heater when not in use.4. Do not operate any heater with a damaged cord or plug or afterheater malfunctions, has been dropped or damaged in any way.5. Do not use outdoors.6. This heater is not intended for use in bathrooms, laundry areasand similar indoor locations. Never locate heater where it mayfall into a bathtub or other water container.7. Do not run cord under carpeting. Do not cover cord with throwrugs, runners or the like. Arrange cord away from traffic area andwhere it will not be tripped over.8. To disconnect heater, turn controls to "OFF" before removingplug from outlet.9. Do not insert or allow foreign objects to enter any ventilationor exhaust opening as this may cause an electric shock or fire ordamage the heater.10. To prevent possible fire, do not block air intakes in anymanner.11. Use this heater only as described in this manual. Any otheruse is not recommended by the manufacturer which may causefire, electric shock or injury to people and/or animals.12. Always use properly grounded fused and polarized outlets.13.Always use ground fault protection where required byelectrical codes.14. Always disconnect power before performing any cleaning,maintenance or relocation of heater.15. Always plug heaters directly into a wall outlet/receptacle.Never use with an extension cord or relocatable power tap(outlet/power strip).16. To prevent a possible fire, do not burn wood or othermaterials in this heater.17. To prevent electric shock or fire, always use a certifiedelectrician should new circuits or outlets be required.18. When transporting or storing heater, keep in a dry place freefrom excessive vibration and damage.19. The heater must not cover up an electrical socket; the socketmust always be accessible in order to disconnect the heater fromthe electrical supply for maintenance and cleaning.20. This heater must be grounded. The main supply must beSafely routed from the heater to an electrical socket.Note: When the heater is turned on for the first time, it mayrelease a slight, harmless odor or smoke. This odor or smoke is anormal occurrence caused by the initial heating of the internalheating elements and should not occur again.SAVE THESE INSTRUCTIONSTechnical SpecificationDescription of product ELECTRIC FIREPLACEModel 80-2000A-36,80-2000A-42,80-2000A-54Rated Voltage 120V~Rated Frequency 60 HzRated Power 1500WLamp LEDUnpacking and Testing1. Carefully remove the unit from the box. Prior to using the unit,test to make sure the unit operates properly. Plug the unit'spower supply cord into a conveniently located 120voltgrounded |
Related manuals for Northwest 80-2000A-36
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine