Notifier AFP-300 Manual

Also see for AFP-300: Operation manual Installation manual Programming manual Product installation guide Programming manual

Contents

specifications

DN-5262 • 10/31/05 — Page 9 of 10AGENCY LISTINGS AND APPROVALSSee the first page of this catalog sheet for listing agenciesand file numbers. These listings and approvals apply tothe basic AFP-300 or AFP-400 control panel. In somecases, certain modules may not be listed by certain ap-proval agencies, or listing may be in process. Consult fac-tory for latest listing status.The AFP-300/400 is UL Listed, per Standards 864 (Fire) and1076 (Burglary). It meets NFPA 72 Local, Auxiliary, RemoteStation, Proprietary, and Emergency Voice/Alarm Fire Sys-tem Requirements.SPECIFICATIONS• Primary input power, 120 VAC, 50/60 Hz, 3.0 Amps.•Total output 24 V power — 6.0 A.*• Standard Bell circuits (4) per MPS-400 — 2.5 A each.• Four-wire detector power — 1.25 A.• Two non-reset regulated power outputs — 1.25 A each.• Battery charger range: 12 AH - 60 AH.(Use separate BB-55 cabinet for 55/60 AH batteries.)• Charge high rate: 29.1 V. Float Rate: 27.6 V.* Note: The MPS-400 has a total of 6.0 Amps of available power.This is shared by all internal modules and each MPS-400circuit.SYSTEM CAPACITY: AFP-400• Intelligent Signaling Line Circuits ............................... 2• Intelligent Detectors ................................................ 198• Addressable monitor/control modules .................. 198• Programmable internal hardwareand output circuits (four standard) ........................... 68• Programmable software zones ................................ 99• Special Programming zones .................................... 14• Programmable remote relay/annunciator points ..... 99• LCD-80 annunciators per system (observe power) 32• ACS annunciators per system...10 Address x 64 pointsSYSTEM CAPACITY: AFP-300• Intelligent Signaling Line Circuits ............................... 1• Intelligent Detectors .................................................. 99• Addressable monitor/control modules .................... 99• Programmable internal hardwareand output circuits (four standard) ........................... 68• Programmable software zones ................................ 99• Special Programming zones .................................... 14• Programmable remote relay/annunciator points ..... 99• LCD-80 annunciators per system (observe power) 32• ACS annunciators per system...10 Address x 64 pointsCONTROLS AND INDICATORSProgram Keypad: QWERTY type (keyboard layout).8 LED indicators: AC Power; Fire Alarm; Pre-Alarm; Secu-rity Alarm; Supervisory Signal; System Trouble, Disabledpoints, Alarm Silenced.Membrane Switch Controls: Acknowledge/Step; Silence;Evacuate; System Reset; Lamp Test.LCD Display: 80 characters (2 x 40) with long-life LED back-light.COMPATIBLE DEVICES, EIA-232 PortPRN-5: 80-column printer.See DN-6769.PRN-6: 80-column printer.See DN-6956.VS4095/S2: Printer, 40 column, 24 V. Mounted in externalbackbox.See DN-3260; order from Keltron, Inc.CRT-2: Video display terminal.See DN-3756.NAM-232W: Wire peer-to-peer NOTI•FIRE•NET™ net-work interface module.See DN-5331.NAM-232F: Fiber peer-to-peer NOTI•FIRE•NET™ net-work interface module.See DN-5331.COMPATIBLE DEVICES, RS-485 PortACS Series: Remote Serial Annunciator/Control systems.See DN-0524.FDU-80: Remote LCD display, 80 characters.See DN-6820.LCD-80: Remote LCD display, 80 characters.See DN-3198.LDM Series: Remote custom graphic driver modules.SeeDN-0551.ACM-8R: Remote relay module, 8 Form-C relays.SeeDN-3558.NIB-96: Network Interface Board.See DN-0597.RPT-485 Series: Repeater, isolator and/or fiber optic mo-dem.See DN-4737.UDACT: Universal Digital Alarm Communicator Transmit-ter.See DN-4867.UZC-256: Zone Coder, up to 256 programmable codes.See DN-3404.COMPATIBLE INTELLIGENT DEVICESBEAMHK: Heating kit for transmitter/receiver unit of FSB-200(S) below.See DN-6985.BEAMHRK: Heating kit for use with the reflector of FSB-200(S) below.See DN-6985.BEAMLRK: Long-range accessory kit, FSB-200(S) below.BEAMMRK: Multi-mount kit, FSB-200(S) below.BEAMSMK: Surface-mount kit, FSB-200(S) below.FSB-200: Intelligent beam smoke detector.See DN-6985.FSB-200S: Intelligent beam smoke detector with integralsensitivity test.See DN-6895.FSI-851: Low-profile ionization detector.See DN-6934.FSP-851: Low-profile photoelectric detector.See DN-6935.FSP-851T: Low-profile photoelectric detector with 135°F(57°C) thermal.See DN-6935.FST-851: Thermal detector 135°F (57°C).See DN-6936.FST-851R: Thermal detector 135°F (57°C) with rate-of-rise.See DN-6936.FST-851H: 190°F (88°C) high-temperature thermal detec-tor.See DN-6936.FSD-751PL: Low-flow photo duct detector with housing.See DN-6955.FSD-751RPL Low-flow photo duct detector with relay andhousing.See DN-6955.FAPT-851: Acclimate Plus™ low-profile multi-sensor de-tector.See DN-6937.FSH-751: HARSH™ Hostile Area Smoke Head.SeeDN-6875.FSL-751: VIEW® laser photo detector, will replace LPX-751.See DN-6886.LPX-751: Low-profile VIEW® laser photo detector.SeeDN-5306.

/ 10

Related manuals for Notifier AFP-300