NFS2-3030 Operations Manual — P/N 52546:N1 06/20//2014 9About This Manual General Information1.3 About This ManualThe following graphics appear in the manual to indicate a caution, a warning, or a note.1.4 Introduction to the Control PanelThe NFS2-3030 is an intelligent Fire Alarm Control Panel (FACP) with features suitable for mostapplications. The CPU2-3030 comes with a front display/keypad option, which allows program-ming and viewing options at the panel.There are two basic configuration options for the NFS2-3030. It can be ordered with:• a front display/keypad, which allows programming and viewing options at the panel, or• no display keypad.This manual gives instructions using the front display/keypad.Displayless ModeWhen there is no keypad/display at the NFS2-3030, the panel is controlled by remote annunciators.VeriFire® programming is required. The displayless panel has four buttons on its circuit board thatare service-level switches for local operation should it become necessary. They are the only but-tons, and are clearly marked with ACK for Acknowledge, SIGSIL for Signal Silence, SYSRST forSystem Reset, and LAMP TEST. These buttons are mainly for installer use: the operator should uti-lize a remote annunciator for these functions, if possible. The status indicator LEDs on the circuitboard are the same as on the display/keypad (refer to Section 1.5.1, “The Display/Keypad”, on page11 of this manual).Refer to VeriFire® Tools or the NCA-2 Manual for information on programming without the NFS2-3030 display/keypad.XP6-C Supervised Control Module Installation Document I56-1805XP6-MA Six Zone Interface Module Installation Document I56-1806XP6-R Six Relay Control Module Installation Document I56-1804FSA-8000 Intelligent Aspiration Sensing Technology Document I56-3903XPIQ Audio Transponder Manual 51013SLC-IM Listing Document LS10026-051NF-ESLC-IM Manual LS10026-000NF-ESWIFT™ Network Manual LS10036-000NF-ETable 1.1 Related Documents (3 of 3)! CAUTION:INFORMATION ABOUT PROCEDURES THAT COULD CAUSE PROGRAMMING ERRORS,RUNTIME ERRORS, OR EQUIPMENT DAMAGE.! WARNING:INFORMATION ABOUT PROCEDURES THAT COULD CAUSE IRREVERSIBLE DAMAGE TOTHE CONTROL PANEL, IRREVERSIBLE LOSS OF PROGRAMMING DATA OR PERSONALINJURY.NOTE: Information that highlights an important part of the preceding or subsequent text orillustration.