Nouveau Kitchens DW100N User Manual
           | |
Cleaning and Special MaintenanceFilter AssemblyFor the best performance and results, the filter assembly mustbe keep clean.The filter removes food particles from the wash water, allowingthe water to be recirculated during the cycle. For this reason, it isa good idea to remove any food particles trapped in the filterafter each wash cycle by rinsing the semi-circular filter and cup("A") under running water. To remove the filter assembly, pullthe handle in an upward direction. The entire filter assembly (madeup of the semicircular filter "A" and the fine filter "B") should becleaned at least once a month use a soft brush. To reassemble,inset the entire assembly into the dishwasher, locate it correctlyin its seat and pressing downward.The dishwasher must not be used without the filters. Improperreplacement of the filters may reduce the performance of theappliance.Cleaning the Spray ArmsFood particles may become encrusted on the spray arms and blockthe hole (see "Close up view [interior]" on page 3, letters C-E ).Check the spray arms periodically and clean them when needed.If the dishwasher does not function or does not function correctly,check the following before calling for assistance.The Dishwasher Does Not Start- Is the plug pushed into the socket correctly?- Is the power on in the house?- Is the door closed properly?- Is the Power switch "ON"?- Is the water supply turned on?The Dishwasher Does Not Fill with WaterHave you checked whether:- the water is turned on and the hose is connected properly;- the water supply to the houses on and has sufficient pressure;- the water supply hose is crimped or bent;- the filter for the water supply hose is clogged.The Dishes Are Not Clean- Is the drain hose kinked or bent?- Has the detergent been dispensed?- Are the spray arm holes blocked?- Are the spray arms rotating?The Dishwasher Does Not Drain- Is the drain hose kinked or bent?Lime Deposits or a White Film Form on the Dishes- Is the rinse aid dosage is correct?If, despite all these checks, the dishwasher still does not functionand/or the problem persists, contact your nearest authorised ser-vice centre and provide them with the following information:- The nature of the problem;- The model number (Mod...) and the serial number (S/N...),which are located on the side of the inner part of the door.TroubleshootingABCleaning the Water Inlet FilterPeriodically clean the water inlet filter located in the inlet hose whereit screws onto the tap.- Turn off the water tap, unscrew the hose, remove the filter andclean it carefully under running water. Then refit the filter and tightenthe hose back into position on the tap..8. |
Related manuals for Nouveau Kitchens DW100N
manualsdatabase
Your AI-powered manual search engine