Nouveau Kitchens DW101N User Manual
           | |
.5.Turning on the ApplianceStarting a wash cycle- Make sure that the plug for the appliance is inserted into thewall socket.- Make sure that the water supply is turned on to full pressure.- Load the dishwasher (see the section entitled, "Loading theDishwasher" on page 4).- Pour in the detergent (see the section entitled, "Detergentand Rinse Aid" on page 3).- Turn the knob located on the right of the control panel inclockwise direction until the number or symbol for the cycle setting isaligned with the reference mark (see the section entitled,"Wash Cycle Table" on page 7).- Press the POWER button, and the POWER light will turn on.At this point, the wash cycle will begin.Cancelling or modifying a wash cycle settingA cycle that is underway can only be modified if it has beenrunning for a short time. Otherwise, the detergent may have al-ready been used, and the appliance may have already drainedthe wash water. If this is the case, the detergent dispenser mustbe refilled (see the paragraph entitled, "Loading the Detergent"on page 3).Press the POWER button, and the ON light will turn off. Rotatethe knob in clockwise direction to the desired cycle setting (seethe section entitled: Starting a wash cycle?F. Then, turn thedishwasher back on using the POWER button.If you forget to load some of the dishesThe wash cycle can be interrupted by pressing the POWERbutton. You can then load additional dishes and turn the appli-ance back on. The cycle will start where it left off.Wait a few minutes before unloading the dishwasher to avoidhandling the dishes and utensils while they are still hot and moresusceptible to breakage. They will also dry better.Wash Cycle Adjustment ButtonsEco ButtonThis button (see "close-up View - Control Panel" on page 1, let-ter "G" ) is used for normal dirty dishes, pots and pans. It is astandard daily cycle. This button reduces the washing tempera-ture from 60=to 50I=saving energy costs.Half load ButtonThis button (see "close-up View - Control Panel" on page 1,letter "H" ) makes it possible to wash dishes using only the up-per rack if there are not enough dishes for a full load. This willallow you to save on water and electricity.FastThis button (see "close-up View - Control Panel" on page 1,letter "I" ) , when pressed with wash cycle 4 (glassware) make itpossible to run the wash cycle at a lower temperature (50)and eliminates the drying phase.It can be used before setting any of the wash cycles, except forthe intensive cycles (if included in the wash cycle table ). Pleasekeep in mind that the amount of detergent should also be cut inhalf.At the end of the wash cycleWhen the knob stops turning and is aligned with a STOP mark(see figure), the cycle has finished. Turn off the appliance usingthe POWER button, turn off the water supply and open the doorof the dishwasher. |
Related manuals for Nouveau Kitchens DW101N
manualsdatabase
Your AI-powered manual search engine