NovaStar C1 User Manual
                                                  | |
Contents
| 
C1User Manual 2 Hardware Introductionwww.novastar.tech 11Figure 2-11 Buttons in TRANSITION area SWAP: Press this button to set the mode of interacting between PVW and PGMinformation as swapping. AUTO FADE: Press this button to set the transition effect as auto fade. MORE: Press this button to enter the effect selection page. TAKE: Press this button to send a layer from PVW to PGM with a transitioneffect. CUT: Press this button to send a layer from PVW to PGM without a transitioneffect. T-Bar: Move the T-Bar to manually control the interacting between PVW andPGM information. The T-Bar supports only the fade transition effect.2.3 Rear PanelFigure 2-12 Rear Panel1. ON/OFF: Power switch2. AC 100-240 V–50/60 Hz: AC power input3. ETHERNET: An Ethernet port connecting to a device to be controlled by theC14. USB: A type-B USB port connecting to an upper computer to update the C1program5. U-DISK: A type-A USB port connecting to a USB drive to upgrade the C1program and import the BKG files6. MONITOR IN: An HDMI-type monitoring connector that connects to the |
Related manuals for NovaStar C1
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine