© Focusrite Audio Engineering LTD 21!! Light all LEDs using SysEx$The side LED cannot be updated by this message.Host >> Launchpad Pro: F0h 00h 20h 29h 02h 10h 0Eh F7h(240,0,32,41,2,16,14,,247)The parameter cannot be repeated in this message.Flashing!Launchpad Pro supports flashing between two colours on Programmer layout and Ableton Livemode, but implemented quite differently. In Ableton Live mode, the flash colour is set by sendinga Note On message (or CC for the round buttons) to the device on channel 2. When a message isreceived on channel 2, Launchpad Pro will then begin to flash between the flash colour (B) andthe current colour of the LED (A), with a 50% duty cycle. See figure 16.Programmer mode does not reserve the MIDI channels for flashing, instead it uses a SysExmessage to implement flashing.Flashing (and pulsing) happens in time with MIDI beat clock (see ‘MIDI Clock’ below), the lastknown tempo or will default to 120 bpm. Flashing can be stopped by sending the LED a messageon channel 1.!!!!!!!!!!!!!!! Flash LED using SysEx$The LED will flash between the chosen colour and its current colour. The side LED can also beupdated by this message. It has an LED index of 99 (63h).$Host >> Launchpad Pro: F0h 00h 20h 29h 02h 10h 23h F7h(240,0,32,41,2,16,35, , , 247)The parameter pair may be repeated in the message up to 97 times.To stop flashing just send a standard Note On message or SysEx message to the same pad and itwill be cancelled.Figure$16:$The$flashing$waveform$
