Installing or Upgrading Novell eDirectory on NetWare 15novdocx (en) 22 June 2009IMPORTANT: This window might close before you enter this information. If it does, toggle(Alt+Esc) to the screen and enter the information. Otherwise, the installation will not becomplete.NOTE: In eDirectory 8.8 and later, you can have case sensitive passwords for all the utilities.Refer to Novell eDirectory 8.8 What's New Guide (http://www.novell.com/documentation/edir88/index.html) for more information.6 In the LDAP Configuration screen, specify which LDAP ports to use, then click Next.For more information, see “Communicating with eDirectory through LDAP” on page 29.7 Perform the following and click Next:7a Select the NMASTM login method you want to install.See “Installing NMAS Server Software” on page 15 and “Installing NMAS ClientSoftware” on page 16 for more information.7b Specify whether to configure the SecretStore module. By default, the SecretStore option isselected.8 Click Finish to start the eDirectory installation.9 To complete the installation, remove any diskettes or CDs when prompted, then click Yes torestart the server.1.6.2 Server Health ChecksWith eDirectory 8.8, when you upgrade eDirectory, a server health check is conducted by default toensure that the server is safe for the upgrade: Section B.3.2, “Partitions and Replica Health,” on page 155Based on the results obtained from the health checks, the upgrade will either continue or exit asfollows: If all the health checks are successful, the upgrade will continue. If there are minor errors, the upgrade will prompt you to continue or exit. If there are critical errors, the upgrade will exit.See Appendix B, “eDirectory Health Checks,” on page 153 for a list of minor and critical errorconditions.Skipping Server Health ChecksTo skip server health checks, enter No when you are prompted to perform the health check.For more information, see Appendix B, “eDirectory Health Checks,” on page 153.1.6.3 Installing NMAS Server SoftwareNovell Modular Authentication ServiceTM (NMAS) server components are installed automaticallywhen you run the eDirectory installation program. You will need to select the login methods youwant to install.
