Novell IDENTITY MANAGER 3.6.1 - WORKORDER DRIVER IMPLEMENTATION GUIDE 18-12-2009 Implementation Manual

Also see for IDENTITY MANAGER 3.6.1 - STAGING BEST PRACTICES GUIDE 2010: Installation guide Reporting guide Overview Manual Manual

Novell IDENTITY MANAGER 3.6.1 - WORKORDER DRIVER IMPLEMENTATION GUIDE 18-12-2009 Implementation Manual Manual pdf 19 page image

Creating a New Driver419novdocx (en) 17 September 20094Creating a New DriverAfter the WorkOrder driver files are installed on the server where you want to run the driver (seeChapter 3, “Installing Driver Files,” on page 17), you can create the driver in the Identity Vault. Youdo so by importing the basic driver configuration file and then modifying the driver configuration tosuit your environment. The following sections provide instructions: Section 4.1, “Creating the WorkOrder Container in the Identity Vault,” on page 19 Section 4.2, “Creating the Driver in Designer,” on page 19 Section 4.3, “Creating the Driver in iManager,” on page 22 Section 4.4, “Activating the Driver,” on page 254.1 Creating the WorkOrder Container in theIdentity VaultThe WorkOrder driver requires you to specify an Identity Vault container for WorkOrder objects andWorkToDo objects. You can use an existing container for these objects, but we strongly recommendthat you create a new container. You can give the container any name you want (for example,WorkOrders). You should restrict rights to the container so that only authorized administrators canchange the container or the objects it holds.4.2 Creating the Driver in DesignerYou create the WorkOrder driver by importing the driver’s basic configuration file and thenmodifying the configuration to suit your environment. After you’ve created and configured thedriver, you need to deploy it to the Identity Vault and start it. Section 4.2.1, “Importing the Driver Configuration File,” on page 19 Section 4.2.2, “Configuring the Driver Settings,” on page 20 Section 4.2.3, “Deploying the Driver,” on page 21 Section 4.2.4, “Starting the Driver,” on page 214.2.1 Importing the Driver Configuration File1 In Designer, open your project.2 In the Modeler, right-click the driver set where you want to create the driver, then select New >Driver to display the Driver Configuration Wizard.3 In the Driver Configuration list, select WorkOrder, then click Run.4 On the Import Information Requested page, fill in the following fields:Driver Name: Specify a name that is unique within the driver set.WorkOrder Container: Browse for and select the container you’ve created for WorkOrderobjects (see Section 4.1, “Creating the WorkOrder Container in the Identity Vault,” onpage 19).