Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual

Also see for ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - NETWORK DISCOVERY DATABASE STRUCTURE: Manual Reference guide Command reference guide Deployment guide Getting started guide

Contents

Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual Manual pdf 84 page image

84 ZENworks 10 Configuration Management Administration Quick Startnovdocx (en) 16 April 2010You can run the commands locally on the device by using the zac command line utility. If the agentwas installed on the Linux device by using an xsession or ssh session, you need to run zac byentering the command /opt/novell/zenworks/bin/zac. However, after logging in again, youcan run zac directly from the command line without typing the full path.Package OptionsYou can use the options listed below when launching a deployment package from the command line.The syntax is:package name option1 option2 ...For example:SatelliteServer.bin -k regkey1-d target_path: Extracts the files to the specified target path. The default target path isc:\opt\novell\zenworks\stage.-h: Displays help information.-k: The registration key used to register the device in the management zone.-l: Lists the contents of the package only. Does not extract the package and run the installation.-n: Extracts the package but does not run the installation.-v: Turns on verbose screen logging.In addition to the options listed above, there are two additional BUILDTIME options (-f file and -ooutput_file) that are used when building packages. These options should only be used under thedirection of Novell Support.5.3.3 ZENworks Control Center Deployment TaskTo install the Adaptive Agent by using a deployment task, the target device must be displayed inZENworks Control Center. This means you must have already completed Section 5.1, “DiscoveringNetwork Devices,” on page 79 or Section 5.2, “Importing Devices,” on page 80.To create a deployment task:1 In ZENworks Control Center, click the Deployment tab.The Deployable Device panel lists all the devices (imported or discovered) to which you candeploy the Adaptive Agent.