Novell ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 Installation Manual

Also see for ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5: Manual Administration guide

Contents

Novell ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 Installation Manual Manual pdf 68 page image

68 ZENworks Endpoint Security Management Installation Guidenovdocx (en) 17 September 20098 Click Install to create the MSI image. Click Finish to close the setup program.9 Browse to the location where you created the MSI image and open the \ProgramFiles\Novell ZENworks\Endpoint Security Client\ folder.10 Copy the Management Service SSL certificate (ESM-MS.cer, or the enterprise certificate) andthe Novell license key into this folder, replacing the default 0 KB files currently in the folder.The ESM-MS SSL certificate is available in the ZENworks Endpoint SecurityManagement Setup Files folder. The license key is e-mailed separately. If you are using the60-day evaluation, no license key is necessary at this time.9.2.4 Command Line VariablesCommand Line variable options are available for an MSI installation. These variables must be set inthe executable shortcut that is set to run in administrator mode. To use a variable, the followingcommand line must be entered in the MSI shortcut:“...\setup.exe” /a /V"variables". Enter any of the commands below between the quotationmarks. Separate multiple variables with a single space.The following command line variables are available:Table 9-1 Command Line VariablesCommand Line Variable Description Notes/qn Quiet install. Suppresses the typical MSIInstallation process. The EndpointSecurity Client will activate at the nextuser reboot.SESMSG=1 Shows a message to the end userthat files in “Safe Harbors” cannotautomatically have encryptionremoved if an Encryption Policy isdeployed.The default value is 0 (don’t displaymessages) in order to make theuninstall “silent.”