Confidential and Proprietary Version DRAFT 2004APR29 7 of 11Novra A75 Receiver4.0 MANAGEMENT CONSOLE SYSTEM CONFIGURATIONS4.1 Configuring the A75 Data ReceiverThe data receiver configuration is very straightforward and can be shown in four basic steps:1. Open (run) the A75 Management Console application2. Configure the receiver IP addresses.3. Set the receive channel.4. Set the PID.Each of these three basic steps is presented below.Step 2: In figure 2, the A75 receiver IP addresses are configured according to the LAN at the receive site.Figure 2: Receiver IP AddressesStep 3: In figure 3, the receiver is tuned to channel 14, to match the broadcast modulator.

INTRODUCTION

INSTALLATION

MANAGEMENT CONSOLE SYSTEM CONFIGURATIONS

A75 RECEIVER SPECIFICATIONS

APPENDIX Miscellaneous Terms and Definitions

Novra A75 Instructions Manual

user manual

Conventions

Introduction

Getting Started

what information do i need – basic configuration

SOFTWARE Installation on Windows 2000, or XP

Configuring the A75

Channel Button

Content Button

Adding Video PIDs

Load/Save Button

Create a Configuration File from the Current Device

Load a Configuration File and Apply All

Load a Configuration File

Status Button

Troubleshooting

Specifications

Minimum System Requirements

A75 ATSC