Novra S300 User Manual

Also see for S300: User manual Setup guide User manual

Novra S300 User Manual Manual pdf 27 page image

Version: 2.02 Confidential and Proprietary 27 of 50Figure 9 - Content Configuration Screen4.3.1.1 Video Program SelectionSelecting the Video Program Selection tab will bring up the screen shown above in Figure . Thepurpose of this screen is to enable the operator to configure the S300 to receive an MPEG Video programand assign it to a multicast IP address so that it can be forwarded onto the receiver LAN. The process to dothis is quite simple – enter the program ID and the multicast IP address/port and select Apply.The video selection screen is split into three sections. The right-most screen displays the Program Guidewhich is parsed out from the Transport Stream SI tables by the S300. Occasionally it takes a few seconds forthis part of the screen to be updated. The Refresh button below the Program Guide may be used tomanually refresh the Program Guide contents.