NuTone 9297T Installation Instructions Manual

Contents

installation instructions

NuTone 9297T Installation Instructions Manual Manual pdf 1 page image

IMPORTANT SAFETY INSTRUCTIONSWARNING – TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOW-ING:1. All electrical work must be done in accordance with local and/or national electrical code as applicable. For safety, this prod-uct must be grounded. If you are unfamiliar with methods ofinstalling electrical wiring, secure the services of a qualifiedelectrician.2. Turn off power at service entrance before installing, wiring orservicing this product.3. This product is designed for horizontal ceiling installation only.Do not mount this product on a wall or sloped ceiling.4. Do not install heater closer than 12" to any adjacent verticalsurface.5. To avoid electrical shock:• Do not install unit in a tub or shower enclosure.• Never place a switch where it can be reached from a tub orshower.6. Provide heater with a separate 20 amp (minimum), 120 VACcircuit.7. Do not connect heater to dimmer switch or speed control.8. To avoid motor bearing damage and noisy and/or unbalancedimpellers, keep drywall spray, construction dust, etc. off powerunit.9. Please read specification label on product for further informa-tion and requirements.INSTALLATION INSTRUCTIONSREAD & SAVE THESE INSTRUCTIONS!Ceiling HeaterMODEL: 9297TFIGURE 1PLAN THE INSTALLATIONThis heater is intended to be used to supply supplemental heatfrom a ceiling location in new or existing construction.Choose a location where edge of heater will be at least 12" fromany adjacent vertical surface.The heater can be operated using an ON/OFF switch, timer (ModelVS62WH 60-Minute or Model VS63WH 15-Minute Timer). Pur-chase the control separately.Plan to supply the heater with proper line voltage and appropriatepower cable for its maximum wattage rating.The heater attaches directly to a standard 3" or 4" ceiling electricalbox.Refer to FIGURE 1Follow these basic steps when installing this heater:1. Mount electrical box in ceiling and attach power cable to it.2. Connect wiring and fasten heater to electrical box.3. Install grille.CEILING JOISTHEATERGRILLE SCREWDRYWALLCEILINGELECTRICALBOX