NuTone Allure WS2 SERIES Instructions Manual

Also see for ALLURE WS2 SERIES: Instructions Instructions Instructions

Contents

Page 5ALLURE ® WS2 SERIESRANGE HOODINSTALL HOODKEYHOLE (4) MOUNTING SCREW (4)1 Hang hood from (4) Mounting Screws. Slide hood towardswall until mounting screws are engaged in narrow end of (4)Keyholes. Securely tighten mounting screws using a longscrewdriver.5 Reinstall filters, turn on power at service panel, and test forproper operation.3 Connect ductwork to hood. Use Duct Tape to make jointssecure and air tight.DUCTTAPE2 Replace bottom cover.PAR20,50W MAX.HALOGENBULB (2)- or -R16,40W MAX.INCANDESCENTBULB (2)4 Install (2) PAR20, 50 W Maximum Halogen Bulbs or(2) R16, 40 W Maximum Incandescent Bulbs (bulbs soldseparately).! CAUTION: Bulbs may be hot! Refer to bulb packagingfor further information.CONNECT WIRINGWARNING: To reduce the risk of electric shock,make sure power is switched off at the servicepanel. Lock or tag service panel to prevent powerfrom being switched on accidentally.HOUSEWIRING(120 VAC)CARDBOARD(Use to protectcooktop)1 Connect House Wiring (120 VAC) to hood. Use a piece ofCardboard to protect the cooktop, if necessary.2 Connect house BLACK to hood BLACK wire, house WHITE tohood WHITE wire, and house ground under GREEN GroundScrew. Securely tighten cable clamp onto house wiring.GREENGROUNDSCREW

/ 8

Related manuals for NuTone ALLURE WS2 SERIES