NuTone CFH52BS Installation Manual

Contents

MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WHPage 1READ AND SAVE THESE INSTRUCTIONSHUGGER SERIESCEILING FANSWARNINGTO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURYTO PERSONS, OBSERVE THE FOLLOWING:1. Use this unit only in the manner intended by the manufacturer. Ifyou have questions, contact the manufacturer at the address ortelephone number listed in the warranty.2. Before servicing or cleaning unit, or installing a light kit, switch poweroff at service panel and lock service panel to prevent power frombeing switched on accidentally. When the service disconnectingmeans cannot be locked, securely fasten a prominent warningdevice, such as a tag, to the service panel.3. Installation work and electrical wiring must be done by a qualifiedperson(s) in accordance with all applicable codes and standards,including fire-rated construction codes and standards.4. When cutting or drilling into wall or ceiling, do not damage electricalwiring and other hidden utilities.5. This unit must be grounded.6. Do not use this fan with any solid-state fan speed control device.7. Most outlet boxes commonly used for the support of lighting fixturesare not acceptable for fan support and may need to be replaced,consult a qualified electrician if in doubt.Use only UL Listed outlet boxes marked “FOR FAN SUPPORT”.The outlet box and support structure must be securely mounted andcapable of reliably supporting a minimum of 50 pounds. Use onlythe two steel screws (and lock washers) provided with the outlet boxfor mounting the ceiling fan to the outlet box The outlet box mustnot twist or work loose. DO NOT USE PLASTIC OUTLET BOXES.8. After marking electrical connections, spliced conductors shouldbe turned upward and pushed carefully up into outlet box. Thewires should be spread apart with the grounded conductor and theequipment-grounding conductor on one side of the outlet box.9. Electrical diagrams are for reference only. Light kits that are notpacked with the fan must be UL Listed and marked suitable for usewith the model fan you are installing. Switches must be UL GeneralUse Switches. Refer to the instructions packaged with the light kitsand switches for proper assembly.10. After installation is complete, make sure that all connections aresecure to prevent the fan from falling. Make sure all wire connectionsare secure, and that there are no exposed conductor strands.11. Do not use water or detergents when cleaning the fan or fan blades.A dry dust cloth or lightly dampened cloth will be suitable for mostcleaning.CAUTIONTO REDUCE THE RISK OF PERSONAL INJURY, OBSERVE THEFOLLOWING:1. To avoid motor bearing damage and noisy and/or unbalancedimpellers, keep drywall spray, construction dust, etc. off power unit.2. The fan must be mounted with at least 7 feet of clearance betweenfan blades and floor.3. Make sure that your installation will not allow the fan to come intocontact with any adjacent obstacles such as doors, hanging lamps,etc.4. If you are installing more than one ceiling fan, do not mix the bladesets.5. Do not bend the blade brackets.6. Do not operate reversing switch while fan blades are in motion.Fan must be turned off and blades stopped before reversing bladedirection.7. Do not insert objects in between rotating fan blades.8. Be careful when working around or cleaning the fan.9. Please read specification label on product for further informationand requirements.WEIGHT OF FANThe weight of your fan is 15.2 lbs.. The weights of light kits, down rods,and ceiling adapters are listed in the instructions packed with thoseaccessories.INSTALLER:Leave this manual with thehomeowner.HOMEOWNER:Use and care instructions onpages 6 & 7.