NuTone QS130 User Manual

Also see for QS130: User guide

Contents

Page ALLURE® QS1 SERIESRANGE HOODWARNING: To reduce the risk of electric shock,disconnect from power supply before cleaning.Aluminum mesh filters: Clean frequently using hot water and amild detergent. Filters are dishwasher safe.Charcoal filters: Clean filter surfaces frequently with a damp clothand a mild detergent. DO NOT immerse filters in water or put indishwasher. The special “Clean Sense” feature indicates when thefilter is to be replaced. The blue and yellow strips will blend to greenwhen it is time to change the filter. The “Clean Sense” feature worksbest when facing toward the cooking surface.To clean hood: Remove filters. Use a damp cloth and a mild deter-gent to wipe all grease-laden surfaces. Use care when cleaning fanblade - it must not become bent or misaligned. DO NOT ALLOWWATER TO ENTER MOTOR. Make sure all surfaces are completelydry before re-installing filters and restoring power.Motor is permanently lubricated. Do not oil or disassemble motor.OPERATIONCLEANINGFan: The 3-position rocker switch (on the left) controls the fan. Theleft position is low speed, center position is off, and right position ishigh speed. An indicator light shows that the fan is on.Light: The 3-position rocker switch (on the right) controls the lights.The left position is low light intensity, center position is off, and rightposition is high light intensity.INSTALL HOODKEYHOLE(4)MOUNTINGSCREW(4)1 Hang hood from (4) Mounting Screws (from parts bag).Slide hood towards wall until mounting screws are engagedin narrow end of (4) Keyholes. Tighten mounting screwssecurely.PAR20,50W MAX.HALOGENBULB (2)- or -R16,40W MAX.INCANDESCENTBULB (2)4 Replace filters and make sure fan blade turns freely. Turn onpower at service panel, and test for proper operation.2 Connect ductwork to hood. Use Duct Tape to make jointssecure and air tight.DUCTTAPECAUTION DO NOT PUSH ON FAN BLADE. Pushing on theblade may cause it to interfere with other hood parts.3 Install (2) PAR20, 50 W Maximum Halogen Bulbs or (2)R16, 40 W Maximum Incandescent Bulbs. Purchase bulbsseparately.! CAUTION: Bulbs may be hot! Refer to bulb packagingfor further information.If hood is to be installed Non-Ducted:Purchase a set of (2) non-ducted filters from your local distributoror retailer and attach them to the aluminum mesh filters.NON-DUCTED FILTERS