NuTone QT20000 Important Safety Instructions Manual

Also see for QT20000: Installation instructions

Contents

4WIRING CONNECTIONSAll wiring connections must comply with local codes and the unitmust be properly grounded.1. Make sure box connector is secure.2. Refer to FIGURE 8. Make wiring connections.3. Replace electrical box cover and secure with screw.LAMP INSTALLINGOR REPLACEMENT1. Depress sides of light diffuser until tabs of diffuser disengagefrom slots in hood. Remove diffuser.2. Install (2) 40 watt maximum, Type A-15 appliance bulbs.3. Replace difuser in hood by depressing sides and engaging tabsin slots in hood.FILTER INSTALLATIONAND REPLACEMENT1. For ducted operation, install the aluminum mesh filter. For non-duct operation, install the non-ducted filter (Model BPQTF, soldseparately).2. Refer to FIGURE 9. The filter slides into channels at the backof the hood, on either side of the fan compartment, and snapsunder the spring clips near the front of the fan compartment.MAINTENANCEFILTERSIMPORTANT: The aluminum filter should be removed once monthlyand washed in hot detergent water. Rinse in clear, warm water andshake off excess moisture before replacing. The filter may also becleaned in your dishwasher.IN A NON-DUCTED INSTALLATION: Replace filter every 3-6months as needed.CLEANINGThe hood should be wiped off occasionally both inside and outsideusing warm water, mild dish detergent and a soft cloth. Never usescouring powders, steel wool pads or any other abrasive cleanerswhich will destroy the hood’s finish.FIGURE 9FIGURE 8SUPPLY WIRINGWHTBLKGREENOR BARE(GROUND)GREEN GROUNDSCREWWHTHOOD WIRINGBLK