NuTone RL6100-H Installation Instructions Manual

Contents

PREPARATION1. Use the dimensional drawing to lay out the Range Hood’s mount-ing holes, wiring access and ductwork.2. Make cutouts for wiring and ductwork.3. If the hood is to be ducted, install the ductwork so that is flush tothe Range Hood’s mounting surface.• Refer to Figure 1 for Model RL5300-H.• Refer to Figure 2 for Model RL6100-H.• Refer to Figure 3 for Model RL6300-H.4. Run two-conductor wire (with ground) from a power source to thehood location. Bring approximately 12” of wiring through wiringhole in cabinet.5. Drill four 3/32” diameter pilot holes at points where mounting holesare marked in the filler strips or cabinet bottom.6. Insert four (4) mounting screws (not supplied), leaving approxi-mately ¼” of thread exposed. Use No. 8 or No. 10 round headscrews.INSTALLATION1. For RL6100 model, attach duct transition to top or back of hoodusing screws provided. (Refer to figure 4)Note: for horizontal venting the damper in the duct transi-tion may be removed to avoid interference with the wall cap.2. Remove top or back wiring knockout from the hood and feed thewiring into electrical box.3. Align hood’s keyhole mounting slots over the four partially in-stalled screws.4. Making sure the duct positions over the hood’s duct transition,push the hood against the rear wall. Secure hood by tighteningscrews.5. Using a long blade screwdriver, reach into the discharge open-ings and be certain the damper operates freely.6. Secure ducting to hood.WIRING CONNECTIONSAll wiring connections must comply with local codes and the unitmust be properly grounded.1. Make sure box connector is secure.2. Refer to Figure 5. Make wiring connections.3. Replace electrical box cover and secure with screw.COMPLETING ASSEMBLY1. Install 75-watt (maximum) bulb in to receptacle.(Purchase bulb locally).2. Install filter and light lens.REPLACEMENT PARTSShould replacement parts be required, please indicate hoodmodel number and appropriate part number. Contact your NuTonedealer or write to NuTone: Madison and Red Bank Roads, Cincin-nati, Ohio 45227-1599. Attn.: Parts Department.OPERATION AND MAINTENANCENOTE: To avoid risk of fire, electrical shock, or injury, turn offpower at supply before servicing.FILTERSThe aluminum filter should be removed once a week and washedin hot detergent water. Rinse in clear, warm water and shake offexcess moisture before replacing. The filter may also be cleaned inyour dishwasher.CLEANINGThe hood should be wiped off occasionally both inside and out-side using warm water, mild dish detergent and a soft cloth. Neveruse scouring powders, steel wool pads or any other abrasive clean-ers which will destroy the hood’s finish.

/ 4

Related manuals for NuTone RL6100-H