NuTone VX1000C Installation Instructions Manual

Also see for VX550C: Brochure Installation instructions Operating instructions Manual

Contents

NuTone VX1000C Installation Instructions Manual Manual pdf 7 page image

7MODEL CF361 & CF361F (For use withCI370 and 360 INLETS)3. Refer to Figure 10. Nail bracket to side of stud sothat front edge of bracket is flush to front of stud.(The bracket may also be nailed to the front edgeof the stud. See face mounting illustrated. For facemounting, use locating tabs on bracket for properalignment.)4. Refer to Figure 11. Remove cardboard from plasterguard frame. Using four (4) provided screws, attachthe appropriate flanged fitting and inlet seal to backof inlet.5. Replace cardboard in plaster guard frame.MODEL CF329 (For usewith 330 INLETS)6. When using Model CF329,glue elbow to mounting plate.Attach to stud as shown inFigure 12.FIGURE 10FIGURE 12INSTALLATION INNEW CONSTRUCTIONWALL INLET ROUGH-INOnce the locations for wall inlets have been determined, mount all inlet brackets.1. Choose the appropriate mounting bracket for the inlet being installed. (See chart.)2. To locate bracket on wall stud, measure approximately 18" up from finished floor level. (Height may vary accordingto individual preference.)Rough-In Series395 396-1 396-3 CI3301RK CI3303RK CF329 CF361 CF361F CI395RK330 X X X360 X X X X XCI335 XCI358 Rough-In and Wall Valve Sold TogetherCI370 X X X X XCI390 XCI395 XCI398 X X XFIGURE 11