Num'axes CANICOM 200 First User Manual

Also see for Canicom 200 First: User guide Technical support

Contents

Num'axes CANICOM 200 First User Manual Manual pdf 5 page image

If you press the “Beeper” button on the remote control, the receiver collar will emit sound signals. There is no timelimit for this function: the beeper will continue to sound as long as you press the button. The indicator light on thecollar goes from flashing green to permanent green as long as you press the button.It is up to you to use the beeper button depending on the way you want to train your dog. With the beeper button youcan:- send a sound to your dog when it is disobedient,- draw its attention, …It’s very important to always use the beeper in the same way in order not to disturb your dog. 1 to 5 buttons: continuous stimulationsButton 1: lowest stimulation / Button 5: strongest stimulation.Always start with the lowest level of stimulation.Press the button 1, 2, 3, 4 or 5 to send a warning to your dog using stimulations transmitted by the two contactpoints located on the receiver collar, the warning will last as long as you press the button but limited to 8 secondsmaximum. The indicator light on the collar goes from flashing green to permanent red as long as you press thebutton.● Checking/replacing battery of remote controlTo check the condition of the battery, observe the indicator light located on the front of the remotecontrol. If the light indicator flashes green 3 times when you press a button, the battery is weak.Performance (radio range) of the remote control deteriorates as battery becomes weak. You should soonreplace the battery.Replace the old battery with a new one as follows:▪ On the back of the remote control, unscrew the screw and remove the battery cover.▪ Remove the old battery using the special tab.▪ Insert the new battery (3 Volt CR 2430 lithium) making sure the polarity “+” noted on the battery isvisible (ref. Diagram 5). The tab is under the battery.▪ Put the battery cover back in place, making sure the tab is in correct position (inside the battery housing) tomaintain water tightness.▪ Retighten the screw.▪ Check the remote control operates correctly:Press a button: if the light indicator located on the front of the remote control flashes green, the battery isproperly inserted. If the indicator does not light, remove the battery and check the polarity before insertingit once again (ref. Diagram 5: “+” noted on the battery must be visible).“+” of the batterymust be visible Diagram 5When the battery is empty, you can not use the remote control. If pressing a button, the LED located onthe front of the remote control will not light.● Checking/replacing battery of receiver collarTo check the condition of the receiver collar battery, observe the light indicator located on the front of the receivercollar:▪ battery fully charged: flashes slow green.▪ weak battery: flashes quickly red.Replace it with a new 3 Volt Lithium CR2 battery (See § First use from new: Fitting the battery in the receivercollar). Check the receiver collar operates correctly.● Changing the contact pointsTwo different series of contact points are supplied. The length of the contact points must be sufficient to have propercontact with the dog’s skin, enabling the device to operate correctly.If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, removeand replace them with the long ones supplied with the kit. Carefully tighten them manually (do not use anykey).User’s guide CANICOM 200 FIRST – indice A 5/8

/ 8

Related manuals for Num'axes Canicom 200 First