Num'axes CANICOM 200 User Manual

Also see for Canicom 200: User guide Technical support

Gb - 25It’s up to you to use the beeper depending on the way you want to train your dog. With the beeper buttonyou can:- send a sound to your dog when it is disobedient,- draw its attention,…It’s very important to always use the beeper button in the same way in order not to disturbyour dog. F button: Flash stimulationPress the «F» button to send a warning to your dog using stimulations transmitted by two contact pointslocated on the receiver collar for a defined length of time of less than one second.A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light on thecollar goes from flashing green to permanent red as long as you press the button. C button: Continuous stimulationPress the «C» button to send a warning to your dog using stimulations transmitted by two contact pointslocated on the receiver collar, the duration will be as long as you press the button but limited to8 seconds maximum.Nota: Beeps can be associated to the stimulation by pressing first the “C” button and then the button. « + » and « - » : control buttonsUse the “+”/”-“ buttons for rapid adjustment of the stimulation level of the receiver collar.9 levels are available.Level 1: very weak stimulation. Level 9: strong stimulation.Always start with the lowest level of stimulation.Checking/replacing battery of remote controlPerformance (radio range) of the remote control may deteriorate as batteries become weak. Beprepared to replace the battery.To check the condition of the battery, turn on the remote control CANICOM 200 and look at the batterylevel indicator on the LCD screen. The symbols which appear indicate the following: