Num'axes Expert 600 User Manual

Also see for Expert 600: User guide

Contents

Num'axes Expert 600 User Manual Manual pdf 5 page image

User’s guide EXPERT 600 – indice A 5/12 Activate/deactivate the collar with the remote controlA magnet located in the remote control is used to switch the EXPERT receiver collar On or Off.▪ Activate: move the remote control towards the collar so that the magnet position indicator comes into contactwith the red mark on the collar, hold for 1 second (ref. Diagram 5). The green indicator light on the collar willflash indicating that the collar is On.▪ Deactivate: move the remote control towards the collar so that the magnet position indicator comes intocontact with the red mark on the collar, hold for 1 second (ref. diagram 5). The green indicator light on thecollar flashes quickly then goes out indicating the collar is Off.To increase the battery life, we recommend you to deactivate the collar if you are not using it for a longperiod. Coding the remote control and receiver collarEach remote control has its own individual radio operator code. The coding of the remote control with the receivercollar enables the two units to work together.IMPORTANT: before beginning the coding (first use of the receiver collar or re-coding), make sure noother person is using his EXPERT 600 or other products from the NUM’AXES range close by: your receivercollar could accidentally record the code of his remote control. If that occurs, re-code the remote controlwith your receiver collar.CODING PROCEDURE FOR THE 1ST USE1. Activate the remote control: press for 1 second the On/Off button .2. Activate the receiver collar: move the remote control towards the collar so that the magnet position indicatorcomes into contact with the red mark on the collar, hold for 1 second (ref. Diagram 5).3. Move the remote control away from the receiver collar.4. Press the V (vibration) button of the remote control. The collar emits vibrations; it is then synchronized withyour remote control.RE-CODING PROCEDURE (for all codings other than the 1st)1. Activate the remote control: press for 1 second the On/Off button .2. Receiver collar in position “deactivated” (green indicator light Off): move the remote control towards thecollar so that the magnet position indicator comes into contact with the red mark on the collar, hold for 6seconds. The indicator light on the collar lights in fixed green then goes out.3. Move the remote control away from the receiver collar.4. Press the V (vibration) button of the remote control. The collar emits vibrations; it is then synchronized withyour remote control.Diagram 5Activate/deactivate the receivercollar with the remote controlPlace these two areastogether for 1 second