Num'axes Training Soft User Manual

Contents

Num'axes Training Soft User Manual Manual pdf 17 page image

Gb - 17 First use from new Fitting the battery in the EYENIMAL Training Soft receiver collar- Use a coin to remove the battery cover.- Insert the battery (3-V Lithium CR2450) paying attention to follow polarity indicated on the housing.- A beep sound (low pitch) is emitted, indicating the correct installation of the battery. If you do not hearany beep after having inserted the battery, remove it immediately from its housing. Check the polaritybefore trying again.- Put the battery cover back in place and use a coin to close it.Diagram 3 Activate/deactivate the EYENIMAL Training Soft remote controlRemote control is supplied with battery fitted.- Activate: as soon as the battery is in place, the remote control is ready for use.- Deactivate: to deactivate the remote control you have to remove the battery from its housing.To increase the battery life of the remote control, we recommend you to deactivate the unit if you arenot using it for a long period. Activate/deactivate the EYENIMAL Training Soft receiver collarA magnet located in the EYENIMAL Training Soft remote control is used to switch the receiver collar Onor Off.- Activate: move the remote control towards the collar so that the round mark on the remote controlcomes into contact with the white mark on the receiver collar, hold for 1 second (ref. Diagram 4). Theindicator light on the collar will flash in green indicating that the receiver is On.- Deactivate: move the remote control towards the collar so that the round mark on the remote controlcomes into contact with the white mark on the collar, hold for 1 second (ref. Diagram 4). The indicatorlight on the collar will flash from green to red and then off: the receiver is Off.WARNINGMake sure the polarityis correct.Make sure the seal is in correctposition inside the collar beforereplacing the battery cover.