Num'axes iki sonic User Manual

Num'axes iki sonic User Manual Manual pdf 15 page image

Gb - 15Changing modesIn the factory, the collar’s mode is positioned on mode 3 (ultrasounds + vibrations).To change the collar’s mode, when switching on the collar you need to approach and keep themagnetic key in contact with the orange mark.A series of beep sounds is emitted (from 1 to 3 beeps) indicating the selected mode.Keep the magnetic key in contact with the orange mark to run through modes.Remove the magnetic key when you have reached the mode you wish.The collar will memorize your selected mode.Next time you will switch on the collar, your collar will be turned on to the last mode youpreviously selected.The chart below indicates how your collar operates according to the mode you have selected:Setting the barking detection sensitivitySetting the barking detection sensitivity is a very important preliminary operation. In fact, thissetting determines the correct operation of the product.It ensures detection of any barking but helps avoid unnecessary detection.The detection, must therefore be sufficiently sensitive but not overly sensitive. In factory, barkingdetection sensitivity is set on the maximum position (maximum sensitivity).To adapt the detection sensitivity to the barking strength of your dog, you should proceed asfollows:- Remove the 2 screws from the battery cover with a screwdriver.- Remove the battery cover.- Carefully turn the setting screw according to the sensitivity you wish (See. Diagram 5)Caution: the adjustment system has a stop for the minimum sensitivity and a stop for themaximum sensitivity. Turn delicately and without forcing with the supplied screwdriver.Number of beep sounds heard whenswitching modes Mode Operation1 1 ultrasounds only2 2 vibrations only3 3 ultrasounds + vibrations