Fig. 14Fig. 15Fig. 1642EN4. INSTALLATIONAND PRELIMINARYOPERATIONSCAUTIONRISK OF POLLUTIONDo not dispose of packaging in the environment.Before carrying out any installation and adjustmentoperations you must read and fully understand theSAFETY INSTRUCTIONS of this handbook. The com-pany cannot be held responsible for damage to thingsor injury to persons caused by failure to comply withthe safety instructions and installation and mainte-nance instructions contained in this handbook.CAUTIONRISK OF SHORT CIRCUITSBefore connecting the machine to the mainspower supply, please check that the supply vol-tage corresponds to the machine voltage.Place the machine on a flat, level surface to avoidany possible malfunctioning.Never install the machine in areas where it couldcome into contact with jets of water.The machine can be used with the following:- Coffee grains- Decaffeinated coffee powder- Milk (not powdered)The use of any other substance not listed hereabove may cause serious damage to the machi-ne itself.WARNINGWARNINGWARNINGThe machine is designed to operate at tempera-tures ranging from +5°C to +40°C (41°F - 104°F).WARNING4 Particularly the first time, wash the tank with soapywater and then carefully rinse off all soap.5 Fill the water tank with water.6 Make sure that the outside of the water tank is dry.7 Return the water tank to its site.4.1 MACHINEINSTALLATION(VERSION WITH TANK)Switch off the machine before filling or removingthe water tank.Once the machine has been withdrawn from thepackaging, carry out the following instructions:1 Position the unit on a horizontal surface.2 Open the hatch.3 Withdraw the water tank by pulling it upwards.WARNING8 Close the hatch.